Hilti dx 2, Operating Instructions Manual

Page: 9 / 21

1.1.7 Thermal safety precautions
a) If the tool has overheated, allow it to cool down.
Do not exceed the recommended fastener driving
rate.
b) Do not dismantle the tool while it is hot. Allow the
tool to cool down.
c) The tool must be allowed to cool down if the
plastic cartridge strip begins to melt.
1.1.8 Danger of explosion
a) Use only cartridges of a type approved for use
with the tool.
b) Remove the cartridge strip from the tool carefully.
c) Never attempt to pry a cartridge from the mag-
azine strip or tool. Never attempt to open a car-
tridge.
d) Store unused cartridges in a secure place where
they are not exposed to dampness or excessively
high temperatures.
1.1.9 Personal protective equipment
The user and any other persons in the vicinity must
wear suitable eye protection, a hard hat and ear
protection while the tool is in use or when remedying
a problem with the tool.
2 General information
2.1 Safety notices and their meaning
DANGER
Draws attention to imminent danger that will lead to
serious bodily injury or fatality.
WARNING
Draws attention to a potentially dangerous situation that
could lead to serious personal injury or fatality.
CAUTION
Draws attention to a potentially dangerous situation that
could lead to slight personal injury or damage to the
equipment or other property.
NOTE
Draws attention to an instruction or other useful informa-
tion.
2.2 Explanation of the pictograms and other
information
Warning signs
General
warning
Warning:
explosive
substances
Warning: hot
surface
Obligation signs
Wear
protective
glasses
Wear a hard
hat
Wear ear
protection
Symbols
Read the
operating
instructions
before use
Location of identification data on the tool
The type designation and serial number can be found on
the type identification plate on the tool. Make a note of
this data in your operating instructions and always refer
to it when making an enquiry to your Hilti representative
or service department.
Type:
Generation: 01
Serial no.:
en
3
Printed: 14.08.2014 | Doc-Nr: PUB / 5193679 / 000 / 00