4 Accessories, consumables
NOTE
For information about further accessories and fasteners for use with the tool, please contact your local Hilti
representative.
Accessories and cleaning set
Designation
Cleaning set, Hilti lubricant spray, spare parts pack, operating instructions, spall guard
Standard accessories
Designation
Piston, base plate, piston guide, fastener guide, spring guide, catch, annular spring
5 Technical data
Right of technical changes reserved.
Tool
DX 2
Weight
2.4 kg (5.29 lb)
Dimensions (L x W x H)
345 mm (13.58") × 50 mm (1.97") × 157 mm (6.18")
Maximum fastener length
62 mm (2½")
Cartridges
6.8/11 M (27 cal. short) green, yellow, red
Contact movement
16 mm (0.63")
Contact pressure
160 N
Ambient operating temperature range
-15…+50°C (+5…+122 °F)
Recommended maximum fastening rate
450/h
6 Before use
NOTE
Read the operating instructions before you operate the
tool for the first time.
6.1 Checking the tool
2
WARNING
Do not operate the tool when parts are damaged
or when the controls do not function correctly. If
necessary, have the tool repaired at an authorized
Hilti service center.
Check that no cartridge strip is loaded in the tool. If there
is a cartridge strip in the tool, pull it up out of the tool by
hand from above.
Check all external parts of the tool for damage and check
that all controls operate faultlessly.
Check the piston and spring clip for wear and ensure that
the parts have been fitted correctly.
en
5
Printed: 14.08.2014 | Doc-Nr: PUB / 5193679 / 000 / 00
Summary of Contents for dx 2
