![background image](http://html1.mh-extra.com/html/hilti/dst-20-ca/dst-20-ca_original-operating-instructions_2136362037.webp)
*2328430*
2328430
English
33
1. Fit the saw blade on to the centering device on the flange.
▶
The direction-of-rotation arrow on the saw blade
(1)
must point in the same direction
as the direction-of-rotation arrow on the blade guard holder.
2. Position the outer flange on the centering spigot and screw in the clamping screw
(2)
.
3. Turn the saw blade until the cooling-water slots of the inner flange are between the
holes (securing screws for flush-cutting flange) in the saw blade.
If the cooling-water slots are open in the holes, correct cooling of the saw blade
is not ensured
(4)
.
Grease the thread of the clamping screw with the grease provided for the
purpose so that the clamping force necessary to transfer drive to the saw blade
is achieved. Be sure to grease only the thread.
4. Tighten the clamping screw to the specified torque
(5)
.
Technical data
Ring/open-ended wrench (for clamping screw)
19 mm
Tightening torque (M12×25 10.9 clamping screw) 80 Nm
5. Fit the blade guard. → page 36
7.4.3 Installing inner flange (flush cutting)
@
Flange nut
;
O-ring
=
Countersunk-head screws for se-
curing saw blade (6 of)
%
Carrier tool for flush-cut saw blades
&
Blade guard holder
(
Saw arm
)
Tie rod
Summary of Contents for DST 20-CA
