*2328430*
2328430
English
23
6.3 Mounting the rail on the rail supports for normal cutting
@
Rail
;
Rail clamp
=
Rail support
%
Rail clamping plate
&
Rail clamping screw
(
Leveling screw
1. Fit rail hooks on the rail.
Rail hooks may be used only together with rail supports for normal cutting.
2. Engage the rail with the rail hooks in the rail supports and slide the clamping plates
over the edge of the rail.
3. Bring the rail supports into alignment at right angles to the rail and then tighten the rail
clamping bolts.
4. Check and adjust the offset distance of the rail from the cutting line and then tighten
the rail support fastening bolts.
5. Use the leveling screws to compensate for differences in level.
6. Fit end stops at the ends of the rail.
Summary of Contents for DST 20-CA
