![background image](http://html1.mh-extra.com/html/hilti/ds-ws15/ds-ws15_operating-instructions-manual_2136341029.webp)
29
6. Preparing the saw system for use
■
The 5-pole, 400V socket on the control unit may not
be changed or replaced by another type. If necessary,
equip your electric extension cable with the EURO sock-
et (400V, 32 amp, 5-pole) supplied.
■
Cable cross-section and maximum cable lengths
Current
F mm
2
F mm
2
F mm
2
F mm
2
F mm
2
Amps
2,5
4
6
10
16
16
49 m 78 m 117 m 195 m
Not recommended
25
39 m 63 m 94 m 156 m 250 m
32
24 m 39 m 59 m 98 m 156 m
Example: At an average current consumption
of 25 amps and with a conductor cross-
sectional area of 4 mm
2
, the wire saw may
be positioned at a maximum distance of
63 m from the power distribution point.
Cable connection code for 400 V 32 A Euro plug (male)
at the control unit:
PE = earth / ground
N = neutral
L1 = phase
L2 = phase
L3 = phase
■
The maximum load that may be carried by the two
230 V sockets is:
Max.
800 W at both sockets (2
×
800 W), or
Max.
1600 W at one socket (1
×
1600 W)
Transporting the wire saw
■
The wheels on the DS WS 15 drive unit must be fold-
ed up before it is transported in your vehicle or on a trail-
er. The drive unit, control unit and other components
must be secured with suitable belts to prevent them mov-
ing around or falling over.
■
Use suitable lifting gear or non-slip, stable ramps to load
/ unload the equipment into the vehicle or onto the trailer.
■
The DS WS 15 control unit can be moved without any
problem by means of the 2 hand grips. A load may be
applied to the folding surface to the rear of the control
unit. A lifting point is provided for the purpose of trans-
portation by crane.
■
The DS WS 15 drive unit can be easily moved on sol-
6.4
F mm
2
L2
L1
N
PE
L3
id ground on its transportation wheels (located in line
with the centre of gravity) by means of the pull-out T-
bar located at the rear. The wheels can be brought from
the standing position to the transport position (and vice
versa) by one person without any trouble by means of
a lever, whereupon they can then be locked in position
(see fig.
,
). Two lifting points are fitted for trans-
portation by crane.
1
2
Summary of Contents for DS WS15
