Step By Step Instructions for Typical Use Cases
53/89
NXHX 52-JTAG | Getting Started
DOC131004GS02EN | Revision 2 | English | 2013-11 | Released | Public
© Hilscher 2013
2. Connect NXHX 52-JTAG board to NXPCA-PCI adapter board.
Connect one end of the CAB-NXPCA-PCI cable to the 68-pin Dual-port
memory connector of the NXPCA-PCI adapter board (accessible
through cut-out slots in PC housing).
Connect the other end of the CAB-NXPCA-PCI cable to the host
interface connector X1 of the NXHX 52-JTAG board (see position
in
Device Drawing and Positions of the NXHX 52-JTAG
chapter on page
Reconnect your development PC to power supply and switch it on.
3. Finish installation of NXPCA-PCI adapter board under Windows.
After rebooting the development PC, Windows recognizes the new NXPCA-
PCI hardware and wants to finish the installation of the appropriate driver.
If you are using Windows 7 or 8:
Under
Windows 7
and
8
, the
Installing device driver software
message
appears in the Windows task bar. If you have already installed the cifX
Device Driver on your PC (as recommended), Windows automatically
copies the driver files to the appropriate Windows directories. You do not
need to take any action in this.
If you are using Windows XP:
Under Windows XP, the
Found New Hardware Wizard
opens. If you have
already installed the cifX Device Driver on your PC (as recommended), do
the following:
In the start screen of the
Found New Hardware Wizard
, answer the
question
Can Windows connect to Windows Update…?
by selecting
the
No, not this time
option.
Click
Next
button.
In the next screen, answer the question
What do you want the wizard
to do?
by selecting
Install the software automatically
option.
Click
Next
.
Windows then copies the driver files to the Windows directories.
In the
Completing the Found New Hardware Wizard
screen, click
Finish
button.
