LEDs
78/90
10.1.2
LINK-ACT and LINK-1000/LINK100 (reverse side)
From the LEDs on the Gigabit RJ45 Ethernet socket on the reverse side of
the analyzer device NANL-B500G-RE you can see whether the recorded
data is transferred secure from loss to the PC.
Important:
The color of both LEDs must be green! If the right LED lights up in
orange, the transfer rate to the PC is less than 1 Gb/s, by
consequence insufficient bandwidth may occur.
LED
Color
State
Meaning
Reverse side NANL-B500G-RE - Gigabit Ethernet RJ45 socket to the PC (1 port with 1 Gb/s)
LED left side
LINK-
ACT /
RJ45
Ch0
green
On
From the NANL-B500G-RE device to the PC an Ethernet connection is
established.
green
Blinking (12 Hz)
Ethernet data is transferred from the NANL-B500G-RE device to the PC.
off
Off
There is no Ethernet connection between the NANL-B500G-RE device and
PC.
LED right side
LINK-1000
/ RJ45
Ch0
green
On
The Ethernet data of the NANL-B500G-RE device is transferred to the PC
with a transfer rate of 1000 Mbits/s (1 GB/s).
Note!
Only at a data transfer rate of 1 GB/s, the recorded data can be
transferred secure from loss to the PC on.
LINK-100 /
RJ45
Ch0
orange
On
The Ethernet data of the NANL-B500G-RE device is transferred to the PC
with a transfer rate of 100 Mbits/s.
Note!
If the LED at the right side lights orange during the analyzer device
NANL-B500G-RE records large amounts of data, in the device a buffer
overflow happens. The data is no longer transferred to the PC and data
recording is stopped.
LINK-1000
LINK-100 /
J45
Ch0
off
Off
The Ethernet data of the NANL-B500G-RE device is not transferred to the
PC.
Table 20: LEDs NANL-B500G-RE (reverse side)
netANALYZER device NANL-B500G-RE | Installation, operation and hardware description
DOC091110UM26EN | Revision 26 | English | 2019-07 | Released | Public
© Hilscher 2007-2019
