hilscher CIFX M223090AE Series, User Manual

Page: 16 / 55

Installing the hardware 16/55
Component heights
·
The component height on the upper side of the basic card CIFX
M223090AE is higher than the height of 1.5 mm specified by the
standard, because the height of the cable connectors (Ethernet X801,
or fieldbus X802) including the cable is approx. 8.5 mm above the
printed circuit board.
·
The component height on the bottom side of the basic card CIFX
M223090AE complies with the standard specifications.
Panel dimensioning
·
Panel cut-outs and holes for mounting AIFX
To mount the detached network interface Ethernet, the required panel
cut-outs for the LEDs and Ethernet sockets as well as the holes for
mounting the AIFX must be provided on the housing of the PC or
connecting device.
Panel cut-outs The layout for the panel cut-outs must be sufficiently
dimensioned for:
·
Two Ethernet RJ45 sockets (for channel 0 and channel 1),
see also data sheet MOD JACK - MJIM, section
References [ } page 43].
·
The two LEDs COM0 and COM1
Drill holes 2, at a distance of 37.0 mm
Further information The dimensions for the required panel cut-outs or the distance
between the holes can be taken from the dimension drawing of
the AIFX, see section
Dimensions AIFX-V2-RE [ } page 42].
Table 10: Panel cut-outs and holes for AIFX mounting
·
Front panel width When dimensioning the front panel, note the width
of the front panel specified in section AIFX-V2-RE [ } page 34].
CIFX M223090AE Real-Time Ethernet | Hardware description and installation
DOC190704UM02EN | Revision 2 | English | 2020-06 | Released | Public © Hilscher 2020