Hillstone SG-6000 Series Firewall Appliance Installation Manual
shown in Figure 4-2:
Figure 4-2: Setting Parameters for the Terminal Session
3.
Switch on the power supply, and the appliance performs self-test and initializes the
configuration automatically. If the booting succeeds, the system will display the
command line prompt “login”. Enter the default administrator name and password
“hillstone” at the “login” and “password” prompts, press “Enter”. And now you are
successfully logged in and accessing the CLI.
4.
Enter commands to configure or view running status. Enter a question mark “?” to
get help on commands whenever you want.
WebUI
The ethernet0/0 (e0/0) port has a default IP address of 192.168.1.1/24, and all the
management functions of this port are enabled by default. Administrators can access the
WebUI through e0/0.
Perform the following steps to log in the appliance’s WebUI:
1.
Set up the IP address of the management PC on the same subnetwork as
192.168.1.1/24. Connect the management PC to the e0/0 port through an Ethernet
cable.
- 36 -
