6
Safety Instructions
Safety Instructions
Caution:
contents under pressure. Read this before operating.
• Release pressure from the bottle before refilling or replacing parts. This is done by slowly pulling
up the safety valve and holding until all air has been released. Then unscrew the container cap.
Note:
some remaining air may be expelled.
• Inspect the condition of all fittings before each use. Do not attempt to use your sprayer with worn
or damaged parts. These parts should be replaced. (Refer to spare parts list.)
• Safety valve operation: over pumping will cause the safety valve to open and release excess
pressure. It will close when safe operating pressure is reached.
• Safety valve test: fill the bottle completely with clean water and pressurise by pumping. When the
sprayer is fully pressurised the valve should lift, allowing the red indicator to become visible and air
to escape. If this does not happen, replace the safety valve.
• Your sprayer is made from many different types of plastic materials, and although the liquid you
may wish to use is packed in a plastic container, it is not guaranteed that it will not damage your
sprayer. Your sprayer is designed for use with a broad range of domestic water-based herbicides,
fungicides, insecticides and fertilisers. Do not use other types of chemicals as they may be
detrimental to the safe operation of your sprayer.
• Follow chemical suppliers on-pack instructions.
Do
ü
Release pressure before filling/servicing
ü
Release pressure and clean after use
ü
Wear safety goggles and gloves
ü
Wear protective clothing and mask
ü
Spray water-soluble chemicals
ü
Ensure adequate ventilation
ü
Wash hands and face after use
ü
Store away from sunlight
ü
Hand tighten fittings only
ü
Rinse inside of bottle before use
ü
Maintain and service regularly
ü
Read and understand chemical
manufacturers’ safety directions
Do Not
û
Spray flammable liquids or solvents
û
Leave full bottle unattended
û
Eat, drink or smoke when spraying
û
Direct spray on humans or animals
û
Spray in windy conditions
û
Spray in confined spaces
û
Leave within reach of children
û
Overfill the bottle
û
Over-pressurise
û
Stand sprayer near naked flame or
hot surfaces
û
Tighten fittings with pliers, etc.
û
Allow children to use as a toy
û
Modify bottle or safety valve
