Hillphoenix JNRBHSA, Owner'S Installation & Operations Manual

Page: 12 / 59

12
CASE INSTALLATION
TRIM OUT
Drain and Pump Notes:
For the best energy conservation, Hillphoenix recommends
the use of
fl oor drains at the store.
Con fi gurations exist (having ‘FD” at end of the case model
name) which restrict certain selections and tailor the case
for use with store
fl oor drains. For “FD” con fi gured cases,
simply glue up the ship loose P-trap , cleanout, and Tee to
route condensate to the
fl oor drain.
Other case con fi gurations (non-”FD”) allow ordering of
options (pumps and burn-off pans) that manage the conden-
sate for stores without
fl oor drains. The following section
discusses the install of these condensate pumps and
burn-off pans.
Unpack pump, PVC drain trap, and 20 feet of plastic tubing.
Glue supplied PVC drain parts to the drain hub. Orient PVC
drain as needed to allow easy clean-out access for future:
typically clean-out to right side, with tube nipple facing left.
Place pump receptacle under case and ensure conduit /
wires are terminated to main junction box on case top.
Cut short section (18” typical) of tube. Connect from PVC
drain outlet nipple to pump inlet (choice of 4 removable
caps) Push tube toward short edge of pump
IMPORTANT : If
tube pushed towards long end of pump it may interfere with
fl oat that is located beneath motor. The RED ‘ALARM” light
will turn on if tube is holding fl oat up. If the tube holds fl oat
down, the motor will not engage to pump water. To correct,
pull out excess tube, and re-orient away from motor /
fl oat.
Install long section of tube from pump outlet (nipple) and
route to top of case and into evaporative condensate pan.
PVC Drain Trap Pump receptacle
Pump Short tube section to pump inlet
Push towards short edge of pump.
Red “Alarm” light
Long tube section from pump
outlet nipple.
Pump Outlet Nipple
Assembled.