Hillco 3700S, Operator'S Manual, Page: 23 / 40

23
HEADER CALIBRATION
Reference the Operator’s Manual for the 5088, 6088 and 7088 Combines to navigate to the Selection Menu
Screen.
Header Tilt Cal Screens (Hillside and Sidehill Combines)
A. CAL MENU C. LEVEL HEADER
B. HEADER TILT CAL MENU D. ENTER
NOTE: It is recommended that calibration be done without a Header installed.
NOTE: If a Header is attached, the feeder must be raised high enough so that header does not hit the ground if
the header is tilted fully in either direction.
NOTE: To perform calibration, the feeder drive must be OFF and the Combine must not be moving.
NOTE: The feeder faceplate and Header (if attached) will automatically move during this procedure.
1. Use the Service key (1) to highlight the Cal Menu, and then press the Enter key (2) to go to the Cal
Menu Screen 1.
2. Press the Service key (1) to highlight the Header Tilt Cal Menu (B).
3. Press the Enter key (2) to go to the Header Tilt Cal screen.
4. Step 1 (C), before starting the calibration, level the feeder face plate (or Header if attached).
5. Step 2 (D), press the Enter key (2) to confirm the feeder face plate is level and to display the Header Tilt
CW Cal screen (E).