Make sure that the power cable is inserted correctly and that the
compressor is switched on, check that the fuse in the switch has
not blown
.
-
Pressure does not exceed 50BAR and air escapes from the Pressure
Relief Valve
-
Pressure
achieved in the bottle is lower than the target pressure
With the bleed screw open, run the compressor for 5 mins and then
attempt another fill. If the problem persists contact
your retailer.
.
Bottle
valve may cause small pressure loss, adjust pressure on
compressor to compensate
.
Shutting the compressor down
Make sure that the cylinder is removed and bleed screw is opened to release
pressure
.
Maintenance
Change
crank oil
every 50 running hours or once yearly (whichever
comes
first)
Unscrew sight glass to change Crank Oil (make sure you have a
suitable container underneath) and drain.
Regularly check that the Silicone lubrication is free from dirt and
debris
Troubleshooting
9
Storage
-
Compressor will not start
Keep upright at all times
ERNEST H. HILL LIMITED
LONGACRE WAY - HOLBROOK - SHEFFIELD S20 3FS - ENGLAND
Telephone; +44 (0) 114 248 4882
www.hillpumps.com
