Service Manual Viking™M mobile lift • 3EN370401 Rev. 19
97
www.hill-rom.com
l
www.liko.com
Instructions regarding the check points
4 Pivot bolts
Lubricate inner side with
flourflon PTFE grease.
Remove pivot bolt, inner and outer bearing sleeves and hardware. Clean and
lubricate pivot bolt, inner and outer bearing sleeves.
Inspect plastic cover, clean them if necessary.
Flat side down
x2
5 Base opening and closing linkage
Remove hardware covers from middle beam and actuator.
Remove leg from middle beam and actuator.
(a) Remove pivot bolt, inner and outer bearing sleeves and hardware.
(b) Remove link arm cover, bolt and nut.
Remove plastic covers and inspect middle beam edges for burrs.
Clean and i
nspect the three pieces of plastic cover. Replace if cracked or
deformed. (For Spare Part No see the Spare Parts List)
Clean, lubricate and reassemble pivot bolt, bearing sleeves and hardware.
Tighten pivot bolt and apply plastic hardware covers.
Reconnect actuator to link arm. Apply plastic hardware covers.
Leg covers needs to be replaced after 6 years of use.
10.0
