PAGE 6
26
27
28
EFFECTS Processor
2TRK ROUTING. Allows to assigne 2TRK input (6) to the control room/phones output and the
MAIN MIX output.
HEADPHONES Output. Carries the same signal as the control room output (5), which is the
main signal, or the effects solo signal depending on switch (25). The 2TRK signal can be added
to the output depending on the setting of the switch (26).
PHONES/CTRL Level Control. Sets the output level at both the front.side HEADPHONES
output (27) and the rear-side CONTROL ROOM output (5).
D
29
30
31
32
29
31
32
30
USER MANUAL - LMR1202FX RACK MIXER
35
34
33
EFFECTS PRESET Selector. Changes the effects program. See below table for the available 16
settings. The active setting is displayed in the first two digits of the display (31).
EFFECTS VARIANT Selector. Changes one key parameter of the active effects program. See
below table for applicable parameters. The variation setting is displayed in the 2nd two digits
of the display (32).
Display. The 1st two digits show the selected effect program, the 2nd two digits show the
selected variation.
TAP Button. Allows to set a manual speed for the time parameter of effects where time is deci-
sive. See below table for further details. Note that not all effect programs are time-based, in
which case this button will have no function. The TAP LED (34) shows the active speed setting.
TAP LED. Indicates the currently active speed of the time base for certain effects. The speed
can be set by tapping along on the TAP button (33). Note that not all effect programs are
time-based, in which case this LED will be off.
SIGNAL LED. Indicates that the effects processor receives an input signal. The signal fed to the
effects processor is set by the AUX2(FX) controls (16).
CLIP LED. Indicates that the signal supplied to the effects processor is too loud. Reduce the
signal by turning down the AUX2(FX) controls (16).
33
34
34
Summary of Contents for LMR-1202FX
Page 1: ...RevA 09 2017...
