PAGE 5
MONO INPUT section (channels 1-8). These inputs channels can accept mono line input
signals to be connected to the rear-side TRS jacks (10) or mono microphone signals to be
connected to the rear-side XLR jacks (11). The mono input section has the same controls as
the stereo input section (B).
STEREO INPUT section (channels 9/10 and 11/12). These inputs channels can accept
stereo line input signals to be connected to the rear-side TRS jacks (9). The stereo input
section has the same controls as the mono input section (A).
GAIN controls. These controls allow to adjust the input sensitivity in a range of +10 to +60 dB
for the MIC input (11) and +10 to -40 dBu for the LINE input (10). The stting should be
adjusted so that the CLIP LED (14) only flashes occasionally
CLIP LED. Indicates an overload of the input channel. The gain (13) shall be adjusted to make
sure this only flahses occasionally.
EQUALIZER. This is a 2-band shelving equalizer with 80Hz (Low) and 12kHz (High) corner
frequencies and an adjustment range of +-15dB.
AUX buses. These two controls allow to create an independent signal mix from the master
output mix. The AUX1(M) bus is pre-fader and allows a mix independent from the channel
fader settings, useful for monitor applications. The resulting AUX1(M) signal can be picked up
at the rear-panel AUX SEND (M) jack (7). The AUX2(FX) bus is post fader and the levels
depend on the channel fader settings, which is useful for effects applications. The resulting
AUX2(FX) signal can be picked up at the rear-panel AUX SEND (FX) jack (7). Note that this
signal is also fed to the internal effects processor.
BALANCE/PAN control. Allows to set the balance between the left and right main signals. For
channels 1-8, the PAN controls determine the allocation of the mono inputs to the left and
right main outputs; for channels 9/19 and 11/12, the BALANCE controls determine the
balance beween the left and right main signal portions.
CHANNEL FADERS. These 60mm sliding controls determine the level of the respective chan-
nel in the master mix.
AUX Input for channel 9/10. This is a 3.5mm stereo TRS (unbalanced) input, suitable for the
connection of e.g. MP3 players. This AUX input is automatically overriding any other source
connected to this channel once a connector is inserted.
POWER LED. Indicates whether the unit is switched on or off.
PHANTOM POWER LED. Indicates whether the rear-side PHATOM POWER switch (3) is
enabled.
LEVEL Meter. Indicates the main output level at connectors (4) in 4 steps: -20dB (lower white),
0dB (upper white), +6dB (lower red), Clip (upper red).
MAIN FADER. This 60mm sliding control determines the output level.
AUX RETURN volume control. Sets the volume of the signal fed into the rear-side AUX
RETURN jacks (8).
AUX RTN SOLO. Assigns the AUX RETURN signal exclusively to the headphones/control room
outputs (5, 27).
15
17
16
14
13
B
A
18
19
20
21
22
23
25
24
USER MANUAL - LMR1202FX RACK MIXER
Summary of Contents for LMR-1202FX
Page 1: ...RevA 09 2017...
