2.1
Installation of Type I Camera
Before you start:
Both wall mounting and ceiling mounting are suitable for
the turret camera. Ceiling mounting will be taken as an
example in this section. You can take steps of ceiling
mounting as the reference, when adopting the wall
mounting.
Steps:
1.
Disassemble the turret camera by rotating the camera
to align the notch to one of the marks, as shown in the
figure below.
Mark
Notch
Figure 2-1
Disassemble the Camera
2.
Remove the mounting base from the camera body
with a flat object, e.g., a coin.
3.
Paste the drill template (supplied) to the place where
you want to install the camera.
4.
Drill the screw holes and the cable hole (optional) on
the ceiling/wall according to the drill template.
Figure 2-2
Drill Template
Note:
Drill the cable hole, when adopting the ceiling outlet
to route the cable
.
5.
Attach the mounting base to the ceiling/wall, and
secure them with supplied screws.
Self-tapping Screws
Expansion Bolts
Figure 2-3
Attach the Mounting Base to the Ceiling
Note:
The supplied screw package contains self-tapping
screws, and expansion bolts.
For cement wall/ceiling, expansion bolts are required
to fix the camera. For wooden wall/ceiling, self-
tapping screws are required.
6.
Route the cables through the cable hole, or the side
opening.