For cement wall/ceiling, expansion bolts are
required to fix the camera. For wooden wall/ceiling,
self-tapping screws are required.
6.
Route the cables through the cable hole, or the side
opening.
7.
Secure the camera on the mounting base.
1
）
pull out the clip plate, and then to combine the
camera with the mounting base.
2
）
Push the clip plate in, and secure the camera by
tightening the screw.
Screw
Clip Plate
Figure 2-14
Secure the Camera
8.
Connect the corresponding cables, such as power
cord, and video cable.
9.
Power on the camera to check whether the image on
the monitor is gotten from the optimum angle. If not,
adjust the camera according to the figure below to get
an optimum angle.
Pan Position
[0° to 360°]
Tilt Position
[0°to75°]
Rotation Position
[0° to 360°]
Figure 2-15
3-axis Adjustment
1).
Hold the camera body and rotate the enclosure to
adjust the pan position [0° to 360°].
2).
Move the camera body up and down to adjust the
tilt position [0° to 75°].
3).
Rotate the camera body to adjust the rotation
position [0° to 360°].
Note:
Loose the screw on the mounting base before
adjusting the monitoring angle.
2.4
Ceiling Mounting of Type IV Camera
Steps:
1.
Paste the dill template to the ceiling.
2.
Drill the screw holes and cable hole (optional) in the
ceiling according to the drill template.
Drill Template
Hole A: for cables routed through the ceiling
screw hole 1: for Mounting Base
1
1
1
A
Screw
Hole
Cable
Hole
Figure 2-16
Drill Template