HIKVISION iDS-TCE500-B, Operation Manual, Page: 62 / 68

Steps
1. Go to Configuration → System → System Settings → Time Settings .
2. Select Time Zone.
3. Select Sync Mode.
NTP Synchronization
Select it to synchronize the device time with that of the NTP server. Set Server IP, NTP Port,
and Interval. Click NTP Test to test if the connection between the device and the server is
normal.
Manual Synchronization
Select it to synchronize the device time with that of the computer. Set time manually, or
check Sync. with computer time.
Satellite Time
Select it to synchronize the device time with that of the satellite. Set Interval.
SDK
If the remote host has been set for the device, select it to synchronize time via the remote
host.
ONVIF
Select it to synchronize time via the third-party device.
No
Select it to disable time synchronization.
All
Select it, and you can select any mode above.
Note
The time synchronization modes vary with different models. The actual device prevails.
4. Click Save.
10.8 Set DST
If the region where the device is located adopts Daylight Saving Time (DST), you can set this
function.
Steps
1. Go to Configuration → System → System Settings → DST .
2. Check Enable DST.
3. Set Start Time, End Time, and DST Bias.
4. Click Save.
Network Traffic Camera Operation Manual
50