Select it when the two network interfaces are connected to two network cables respectively.
When one network interface fails, the other network interface will be switched automatically
without influencing the data transmission.
Multi-Network Isolation
Select it when different LANs are connected. Set the IP addresses of different network
segments.
Note
The dual-NIC mode varies with different models. The actual device prevails.
3. Set network parameters.
NIC Type
Select a NIC (Network Interface Card) type according to your network condition.
IPv4
Two modes are available.
DHCP
The device automatically gets the IP parameters from the network if you check DHCP. The
device IP address is changed after enabling the function. You can use SADP to get the device
IP address.
Note
The network that the device is connected to should support DHCP (Dynamic Host
Configuration Protocol).
Manual
You can set the device IP parameters manually. Enter IPv4 Address, IPv4 Subnet Mask, and
IPv4 Default Gateway.
IPv6
Three IPv6 modes are available.
Route Advertisement
The IPv6 address is generated by combining the route advertisement and the device Mac
address.
Note
Route advertisement mode requires the support from the router that the device is
connected to.
DHCP
The IPv6 address is assigned by the server, router, or gateway.
Manual
Network Traffic Camera Operation Manual
32
Summary of Contents for iDS-TCE500-B
Page 1: ...Network Traffic Camera Operation Manual...
Page 68: ...UD28262B...