HIKVISION DY5 Series, Quick Start Manual

Page: 14 / 34

Network Positioning System
·
Quick Start Guide
13
2 Installation
Before you start:
Check the package contents and make sure that the device in the package is in good
condition and all the assembly parts are included.
Notes:

Do not power the positioning system up until the installation is finished. To ensure
safety of personnel and equipment, all the installation steps should be done with
power supply off.

The positioning system is much heavier than the normal camera, and it strongly
demands for load-bearing and stability of the upholder. It’s highly recommended to
install the system to the upholder directly.

If you need to install the positioning system to the bracket, refer to bottom view of
the positioning system as shown in section 1.1 Introduction to select the bracket.
The load-bearing and anti-shake capabilities must be fully taken into consideration.
2.1 Installing DY9xxx Network Positioning System
2.1.1 Installing DY9xxx Series Laser Network Positioning System (Type III
and Type IV)
Steps:
1.
Fix the positioning system.
1)
Fix the positioning system onto the bracket pedestal with the supplied M8*30
screws as shown in Figure 2-1 and Figure 2-2.
Figure 2-1 Fix the Positioning System (Type III)