Guidance Terminal User Manual
11
3.
Drill 4 Ø8 screw holes on the wall according to the figure below and fasten the
expansion screws into the drilled screw holes on the wall.
4
5
0
340
4-Ø 8
Unit
：
mm
Figure 2-4
Drill Screw Holes
4.
Align the four installation holes on the machine body to the four expansion screws
on the wall to hook the terminal on the screws.
5.
Connect network cable and power cord in the machine body, and route the cables
from the corresponding outlet holes according to the figure below.
Route the power cord from strong current outlet hole and other cables from
weak current outlet hole.
The weak current outlet hole is used for routing camera power cord, network
cable, etc.
The strong current outlet hole is used for routing the 220 VAC power cord.
