Control Terminal’s User Manual
5
If smoke, odor or noise rise from the device, turn off the power at once and
unplug the power cable, and then please contact the service center.
Cautions:
Read the manual carefully before you use the device.
Make sure the device power is turned off and the plug is unplug from the power
socket when you do the operations, including plug or remove the board card.
Make sure the device power is turned off when plug or unplug any cables.
Wait at least 30 seconds to power on the device if the device is newly shut down
to avoid the device damage by frequent power off/power on.
For some precise unit is quite sensitive to the ESD, make sure electrostatic
discharge has been finished if you want to dismount or assemble the device.
If no ESD workbench is provided, you can follow the tips below to lower the
damage might be caused by ESD.
o
Wear a wrist strap, and touch the metal parts of the device with the wrist
strap.
o
Touch the metal part on the machine instead of the components.
o
Avoid the unnecessary walking around.
o
Hold the edge of the components, especially for the board card.
o
Put all the components on a conducting foam pad.
o
Move the components on the workbench as less as possible.
It is recommended that you use a magnetic cross screwdriver to tighten or loosen
the screws. Make sure no tool or components are left in the machine.
Keep the device away from water and any liquid.
While shipping, the device should be packed in its original packing.
Improper use or replacement of the battery may result in hazard of explosion.
Ensure unit is installed in a well-ventilated, dust-free environment.
Ensure unit is properly secured to a rack or shelf. Major shocks or jolts to the unit
as a result of dropping it may cause damage to the sensitive electronics within the
