4.5.5 Access Control Board UART Description
You can set the device mode, switch the communication mode of the corresponding UART, and
initialize the device through the DIP on the access control board.
The DIP switch of the access control board is shown in the figure below:
Note
The diagram is for reference only.
Figure 4-14 DIP Switch on Access Control Board
DIP A can set the device mode, DIP 2 to 5 can set the RS-485/RS-232 interface, and DIP B can also
be used to initialize the device.
The UART corresponding to the DIP Switch is shown in the figure below:
DS-K3B411SX Series Swing Barrier Quick Start Guide
31
