User Manual of DS-9600/8600/7700/7600NI-ST and DS-7700/7600NI-SP Series NVR
64
Steps
:
1.
Enter the Record settings interface to configure the encoding parameters:
Menu>Record>Encoding
Figure 5.3 Record Encoding
2.
Encoding Parameters Setting for Recording
1)
Select
Record
tab page to configure. You can configure the stream type, the resolution, and other
parameters on your demand.
•
Pre-record:
The time you set to record before the scheduled time or event. For example, when an
alarm triggered the recording at 10:00, if you set the pre-record time as 5 seconds, the camera records
it at 9:59:55.
•
Post-record:
The time you set to record after the event or the scheduled time. For example, when an
alarm triggered the recording ends at 11:00, if you set the post-record time as 5 seconds, it records till
11:00:05.
•
Expired Time:
The expired time is the longest time for a record file to be kept in the HDD, if the
deadline is reached, the file will be deleted. You can set the expired time to 0, and then the file will
not be deleted. The actual keeping time for the file should be determined by the capacity of the HDD.
•
Redundant Record/ Capture:
Enabling redundant record or capture means you save the record and
captured picture in the redundant HDD. See
Chapter 5.7 Configuring Redundant Recording and
Capture
.
•
Record Audio:
Check the checkbox to enable or disable audio recording.
2)
Click
Apply
to save the settings.
Note:
The redundant record/capture is to decide whether you want the camera to save the record files or
captured pictures in the redundant HDD. You must configure the redundant HDD in HDD settings. For
detailed information, see
Chapter 10.4.2 Setting HDD Property
.
3.
Encoding Parameters Settings for Sub-stream
1)
Enter the Sub-stream tab page.
