– 14 –
– 14 –
Fig.
H
2
1
insert
2. Insert two washers (3) into the auxiliary mounting
bracket (2) and align with the hole at the end of the
auxiliary mounting brackets (2). (Fig. I)
3. To mount the auxiliary mounting bracket (2) onto
the saw mounting brackets (4), insert the screws (5)
through the inserted washers (3) into the square
nuts (1) below the saw mounting bracket (4) for
fi
each end of the auxiliary mounting bracket (2) by
using 5 mm hex wrench. (Fig. I)
4. Repeat the above steps of 2 & 3 for assembling the
other auxiliary mounting bracket.
NOTE:
Do not tighten the four screws (5) securely at
this time.
Fig.
I
3
5
1
2
6
6
4
two square
nuts inside
two square
nuts inside
insert
5. Make sure the cam latches (6) of the saw mounting
brackets (4) are in the unlocked position. (Fig. J)
6. Lower the rear and front ends of the mounting
brackets assembly onto the rear and front rails of the
stand.The front holding clamps of the saw mounting
brackets (4) must seat fully on the front rail. Make
sure that the saw mounting brackets are positioned
at right angle to the front and rear rails. (Fig. J)
7. Lock the mounting brackets assembly in position by
pressing down on the two cam latches (6). (Fig. J)
WARNING
•
Ensure that the saw mounting brackets can be
clamped securely on the stand before mounting the
miter saw.
•
To reduce the risk of injury, ensure all bolts and nuts
are properly tightened and all mechanisms properly
function after completing assembling and before
each use.
Fig.
J
6
6
4
Mounting bracket
assembly
WARNING
•
The cutting head on all sliding miter saws must be
locked in both the forward and down positions before
any attempt is make to mount to the stand. Failure to
do so may result in serious personal injury.
•
Stay alert. The stand and miter saw may fall down
during this procedure and cause serious injury.
•
Do not use the miter saw on the stand when the legs
of stand are folded.
•
Layout the power cable neatly to prevent the power
cable causing the stand to tip over when performing
the cutting operation.
8. Unplug the miter saw and lock the cutting head
to its down position. If the miter saw has a sliding
rail, lock the cutting head in the down and forward
position. Put the miter saw on the mounting brackets
assembly.
NOTE:
For your own safety, position the miter saw
on the brackets with the help of two or more people.
9. Slide the square nuts (1) to the slots of the the
auxiliary mounting brackets (2) and align to the
mounting holes of the miter saw. (Fig. K)
10. Insert the bolts (7) through the washers (8), the
mounting holes of the miter saw and the slots of
the auxiliary mounting brackets (2) into the square
nuts (1) to mount and lock the miter saw to the
auxiliary mounting brackets (2). (Fig. K)
NOTE:
Adjust the position of the auxiliary mounting
brackets as close as to the front end of the saw
mounting brackets.
000Book̲UU240F.indb 14
000Book̲UU240F.indb 14
2019/12/26 10:14:06
2019/12/26 10:14:06
