English
43
When the overheat protection feature has been activated, the motor may stop.
In this case, release the tool switch and cool it down in a few minutes.
After that you can use it again.
●
Restart prevention function
When the power is still switched on, the tool will not restart when a battery is installed. This
function can be canceled once the tool is switched o
ff
.
CHARGER
Model
UC18YSL3
Charging voltage
14.4 V–18 V
Weight
0.6 kg
BATTERY REMOVAL/INSTALLATION
1. Battery
removal
Hold the handle tightly and push the battery latches to remove the battery (see
Fig. 3, 4
).
CAUTION
Never short-circuit the battery.
2. Battery
installation
Insert the battery while observing its polarities (see
Fig. 4
).
Fig. 3
Battery Latch
Ventilation holes
Terminals
Battery cover
Battery
Pull out
Insert
Push
Fig. 4
Latch
CHARGING
Before using the power tool, charge the battery as follows.
1. Connect the charger
’
s power cord to the receptacle.
When connecting the plug of the charger to a receptacle,
the charge indicator lamp will blink in red (At 1- second
intervals).
2. Insert the battery into the charger.
Firmly insert the battery into the charger as shown in
Fig. 5
.
Battery
Charger
Charge indicator
lamp
Fig. 5
00Book̲G3618DA̲ChS.indb 43
00Book̲G3618DA̲ChS.indb 43
2021/04/08 14:09:10
2021/04/08 14:09:10
