![background image](http://html1.mh-extra.com/html/hikoki/dh-24ph2/dh-24ph2_handling-instructions-manual_2131594033.webp)
English
33
6. Con
fi
rm the direction of bit rotation (
Fig. 5
)
The bit rotates clockwise (viewed from the rear
side) by pushing the R-side of the push button.
The L-side of the push button is pushed to turn the
bit counterclockwise.
HOW TO USE
CAUTION
To prevent accidents, make sure to turn the switch o
ff
and disconnect the plug
from the receptacle when the drill bits and other various parts are installed or
removed. The power switch should also be turned o
ff
during a work break and after
work.
1. Switch
operation
The rotation speed of the drill bit can be controlled steplessly by varying the amount that
the trigger switch is pulled. Speed is low when the trigger switch is pulled slightly and
increases as the switch is pulled more. Continuous operation may be attained by pulling the
trigger switch and depressing the stopper. To turn the switch OFF, pull the trigger switch
again to disengage the stopper, and release the trigger switch to its original position.
However, the switch trigger can only be pulled in halfway during reverse and rotates at half
the speed of forward operation.
The switch stopper is unusable during reverse.
2. Ro hammering
This rotary hammer can be set to rotation and
hammering mode by pressing the push button
and turning the change lever to the mark
(
Fig. 6
).
(1) Mount the drill bit.
(2) Pull the trigger switch after applying the drill bit
tip to the drilling position (
Fig. 7
).
(3) Pushing the rotary hammer forcibly is not
necessary at all. Pushing slightly so that drill dust
comes out gradually is su
ffi
cient.
CAUTION
When the drill bit touches construction iron
bar, the bit will stop immediately and the rotary
hammer will react to revolve. Therefore grip
the side handle and handle tightly as shown in
Fig. 7.
Push button
Fig. 5
Fig. 6
Push button
Change lever
Fig. 7
000Book̲DH24PH2̲ChS.indb 33
000Book̲DH24PH2̲ChS.indb 33
2019/02/12 10:18:09
2019/02/12 10:18:09