English
20
HOW TO OPERATE
1. Procedure
for
fi
xing the cutting material
(
Fig. 5
and
6
)
Place the workpiece material between vise
(A) and vise (B), raise the clutch and push
the screw handle to bring vise (A) lightly
into contact with the workpiece material, as
shown in
Fig. 5
.
Then, turn the clutch down, and securely
fi
x the workpiece material in position by
turning the screw handle. When the cutting
job is completed, turn the screw handle
2 or 3 times to loosen the vise (A), and
remove the workpiece material, as shown
in
Fig. 6
.
CAUTION
Never remove or install a workpiece
material while the cut-o
ff
wheel is
rotating, to avoid personal injury.
2. Cutting at angles (
Fig. 7
)
(1) The machine permits cutting at angles of 0°
or 45°.
(2) Loosen the two M10 hexagon socket head
bolts on the vice (B), then set the working
surface on the vice-jaw at any angles of
0°, 30°, or 45°. Upon completion of setting,
securely tighten the two M10 hexagon socket
head bolts.
3. Moving the stationary vise-jaw (
Fig. 8
)
The vise opening is set at the maximum of
165 mm when shipped from the factory.
In case an opening of more than 165 mm is
required, move the vise to the position shown
by the chain line after unscrewing the two
bolts. The maximum opening can be set in two
steps 200 mm and 235 mm. When the cutting
material is excessively wide, the vise can be
e
ff
ectively used by repositioning the stationary
side of the vise-jaws.
Vise (B)
Vise (A)
Long workpiece
material
Workpiece
material
Base
Screw handle
Fig. 5
Vise (B) Vise (A)
Clutch
Screw handle
Workpiece
material
Base
Fig. 6
Vise (B)
10 mm bolt
Fig. 7
Hex. bar wrench
165 mm 200 mm
235 mm
Vise (B)
10 mm bolt
Vise (A)
Fig. 8
000Book̲CC14ST̲ChS.indb 20
000Book̲CC14ST̲ChS.indb 20
2017/12/12 11:33:56
2017/12/12 11:33:56