English
19
2. Cutting
(1) Rotate the cut-o
ff
wheel, gently press down the handle, and bring the cut-o
ff
wheel close to
the cutting material.
(2) When the cut-o
ff
wheel contacts the cutting material, gently press down the handle further
and start cutting.
(3) When cutting (or designated slotting) is completed, raise the handle and restore it to its
original position.
(4) At the termination of each cutting process, turn OFF the switch to stop rotation and proceed
with the subsequent cutting job.
CAUTION
It does not necessarily cut rapidly when putting more force on the handle.
Too much force on the handle will put excessive pressure on the motor and reduce
its capacity.
Do not fail to switch OFF the switch after operation is completed and pull the plug
out.
MOUNTING AND DISMOUNTING THE CUT-OFF WHEEL
1
Dismounting the cut-o
ff
wheel (
Fig. 3
and
4
)
(1) Raise Lowergurd (A) and Lowergurd (B).
Press down on the stopper pin to bring it
into contact with the wheel washer.
Rotate the cut-o
ff
wheel, pass the
stopper pin through the hole on the
wheel washer, and then remove the
M10 bolt with the hexagonal spanner
supplied.
(2) Remove the bolt, washer (A), and the wheel
washer and detach the cut-o
ff
wheel. (
Fig. 4
)
CAUTION
Do not remove the O-ring or sleeve from
the cut-o
ff
wheel spindle.
2. Mounting the cut-o
ff
wheel
Throughly remove dust from the wheel
washers and bolt then mount the wheel by
following the dismounting procedures in
reverse order. Return Lowergurd (A) and
Lowergurd (B) to its original position.
CAUTION
Con
fi
rm that the stopper which was used for installation and removal of the cut-o
ff
wheel has returned to the retract position.
Stopper Stopper pin Hole of wheel washer
10 mm bolt
Hex. bar wrench
Wheel washer
Cut-o
ff
wheel
Fig. 3
Sleeve
Cut-o
ff
wheel
spindle
Stopper pin
Wheel washer
O-ring
Cut-o
ff
wheel
Washer (A)
10 mm bolt
Wheel washer
Fig. 4
000Book̲CC14ST̲ChS.indb 19
000Book̲CC14ST̲ChS.indb 19
2017/12/12 11:33:56
2017/12/12 11:33:56
