HAG-125/850
5526
“EGA" Spółka z o.o. Spółka Komandytowa ul. Rzeczna 1, Nowa Wieś Rzeczna
83-
200 Starogard Gdański
• Switch off the tool. Pull the power plug.
• Adjust the guard (5) to protect your hands so that the material being ground is directed
away from your body.
• The position of the guard (5) can be adjusted to any specific working conditions. Undo the
clamp handle (a) and turn the cover (5) into the required position.
• Ensure that the guard (5) correctly covers the gear wheel casing.
• Secure the clamp handle (a) again.
• Ensure that the guard (5) is secure.
Take care that the safety device is secure.
Never use the angle grinder without the guard.
Test run for new grinding Wheels
Allow the right-angle grinder to run in idle for at least 1 minute with the grinding or cutting
wheel fitted in place. Vibrating wheels are to be replaced immediately.
Operation
Switch (Fig.4)
• Plug the cord into the outlet.
• To run the tool, move to the front of the switch.
• If you need to work in continuous mode, you press down on the front part of the trigger
switch, causing it to lock in the on position.
• Release the power button, or when the switch is locked in the on position, press on its rear
part. As a result, the button pops back.
Changing the grinding wheels
(Fig.5)
Use the face spanner (5) supplied to change the grinding wheels.
Pull out the power plug.
• Simple wheel change by spindle lock:
• Press the spindle lock and allow the grinding wheel to latch in place.
• Open the flange nut with the face spanner.
• Change the grinding or cutting wheel and tighten the flange nut with the face spanner.
Important!
