AG-125/850
5526
“EGA” Spółka z o.o. Spółka Komandytowa ul. Rzeczna 1, Nowa Wieś Rzeczna
83-
200 Starogard Gdański
19
Only ever press the spindle lock when the motor and grinding spindle are at a stand-still!
You must keep the spindle lock pressed while you change the wheel!
For grinding or cutting wheels up to approx. 3 mm thick, screw on the flange nut with the fl
at side facing the grinding or cutting wheel.
Fig.3 Fig.4 Fig.5
Flange arrangements when using grinding wheels and cutting wheels (Fig. 6-9)
• Flange arrangement when using a depressed-centre or straight grinding wheel (Fig. 7)
• a) Clamping flange
• b) Flange nut• Flange arrangement when using a depressed-centre cutting wheel (Fig. 8)
• a) Clamping flange
• b) Flange nut• Flange arrangement when using a straight cutting wheel (Fig. 9)
• a) Clamping flange
• b) Flange nut
Rough grinding (Fig.10)
Caution: Use the safety device for sanding/grinding (included in items supplied).For the best
rough grinding results, hold the grin-ding wheel at an angle of
between 30° and 40° to the
workpiece surface and guide back and forth over the workpiece in steady movements.
Cutting
(Fig.11)
Caution: Use the safety device for abrasive cutting (available as accessory, see 8.4)When
you use the right-angle grinder for cutting purposes, avoid tilting it in the cutting plane. The
cutting wheel must have a clean cutting edge. A diamond cutting wheel is best used to cut
hard stone.
