60
Setting Boot Array
1.
Navigate to the array panel (Press
ALT + W
, then press
2
)
2.
Select desired array
3.
Press
ALT + A
to open array tab
4.
Press
Set Boot
5.
Window will close,
reboot
to confirm
Appendix A-4: Controller Tab
Information
Provides certain controller information:
Product ID
PCI Location
IOP Model
SDRAM Size
Firmware Version
Battery Installed
Battery MB Installed
Serial Number
CPU Temperatures (Celcius)
Board Temperature (Celcius)
Controller voltage levels
Setting…
Configures certain settings:
Enable audible alarm
Enable Staggered spin up
Spin down idle disk (minutes)
Enable automatic rebuild
Continue Rebuilding on error
INT13 support
Use single BCV entry
Stop on error
Controller > Setting Information
Enable Audible Alarm
Enables/Disables the RocketRAID
controller alarm
Enable Staggered Spin up
(Default: Disabled)
Enabling this setting
will force the card to power on each hard
disk sequentially (2 seconds between
disks). Check with your disk manufacturer
if your drive supports this feature.
