Highlight HL 721A, User Manual

Page: 9 / 27

HL 721A/B 1351B Plotting Cutter User Manual
Page 9/27
1. Make sure the red “ Reset ” LED stays on.
2. Press “ Offline/Pause ” button, and make sure the yellow LED stays on.
3. Press “ ↑ ” or “ ↓ ” or “ → ” or “ ← ”arrow buttons corresponding to align paper and pen/blade carriage horizontally and vertically to find a
proper stating point.
4. Press “ Origin ” button to Zero the new starting point.
5. Press “ Offline/Pause ” button again, and make sure the yellow LED stays off.
6. Press “ Test ” button, the machine should be able to draw or cut a trial cut.
6.8. Check and Adjust Baud Rate (9600 bps) and Up-Speed
* Keep the baud rate setting as 9600 all the time to match what sets at PC control panel and Artcut application software.
* The Up-Speed is a speed for blade carriage and media film return to starting point after a project is finished.
1. Make sure the red “ Reset ” LED stays on.
2. Press “ Setup ” button, and make sure the green LED stays on.
3. Press “ ← ” or “ → ” arrow buttons to adjust the baud rate, “ ↑ ” or “ ↓ ” arrow buttons to adjust the up-Speed.
6.9. Repeat Previous Cutting Job (Power without been off and reset)
1. Make sure the red “ Reset ” LED stays on.
2. Press “ Offline/Pause ” button, and make sure the yellow LED stays on.
3. Press “ Setup ” button, and make sure the green LED stays on.
* It will not repeat if the green LED flashing which means data error.
6.10. Cancel Current Cutting Job
During a cutting, press the red “ Reset ” button again, it will cancel current job and return to factory default settings.
Up-Speed 570 mm/s
Baud rate 9600
Offline
/Pause
Reset
Setup
Test Origin
Baud rate & Up_speed setting
1 2 3
Offline
/Pause
Reset Setup
Test Origin
Offline trial cut
1 2&5 3
4 6
Up-Speed 570 mm/s
Baud rate 9600
Offline
/Pause
Reset
Setup
Test Origin
Repeat previous cutting
1
2 3
Up-Speed 570 mm/s
Baud rate 9600
Offline
/Pause
Reset
Setup
Test Origin
Cancel current cutting
1&2
HIGHLIGHT
ELECTRONICS