HIGHLEAD GC20688 Series, Instruction Manual And Parts List

Page: 4 / 62

—
3
—
2) Oil pan
(1) Install the oil pan 3 to the underside of the
worktable 1 in the place shown in the illustration using
the nails 2.
(2) From front view, the oil pan 3 to the side is
60mm; from right view, the oil pan 3 to the side is
80mm.
3) Operation panel
(1) Install the operation panel 1 to the
set plate 2 with the three screws 3.
(2) Install the set plate 2 to the back of
the machine arm with the two screws 4.
4) Adjusting the needle stop position
(1) Adjusting the needle up stop position
When the sewing machine stops in the needle up stop position (the stop position of trimming) and the
treadle is pressed back, the red mark on the pulley should be consistent with the mark on the belt cover A.
Adjust as follows:
a. Turn off the power switch.
b. Loosen the screw 4, and then remove the cover 3.