30
FUNCTIONAL INSTRUCTIONS
Connect the stereo RCA output (FL/FR, RL/RR and SUB OUT) of
the head unit with FL/FR, RL/RR and SUB IN of the amplifier.
Loudspeaker
L & R, front
each 2 – 8 Ohms
Loudspeaker
L & R, rear
each 2 – 8 Ohms
Subwoofer
1 – 8 Ohms
Connect the Remote Controller
with the enclosed cable
Connect the USB port to the Compu-
ter with the enclosed USB cable
INTERCONNECTION
• Connect the RCA lineouts of the head unit with the RCA jacks
LINE IN
and
SUB IN
of the amplifier with appropriate high-value
RCA cables. If your head unit is equipped with a separate subwoofer output use this for the
SUB IN
inputs.
• Connect the front and rear speakers with the
SPEAKER A -
and
+ B -
and
+ C -
and
+ D -
as well as the subwoofer with
+ SUB OUT -
by using appropriate high-value cables.
Ensure that the total impedance load on each channel pair
A/B
and
C/D
is not lower than 2 ohms (bridged 4 Ohms) and on the sub-
woofer channel
SUB OUT
not lower than 1 ohm.
REMOTE CONTROLLER
Refer to page 7.
DSP-SOFTWARE SETTINGS
Now connect the DSP amplifier via the included USB cable to the computer on which you installed the DSP software before.
Important:
Until you have made all basic settings, turn down the volume control of the head unit all the way left to the lowest setting to
avoid damage to the sound system.
STARTING THE PROGRAM
Turn on the head unit (radio) and thus the DSP amplifier. Start the DSP
software. Please also refer to the information on page 8 and 9.
CONFIGURATION OF INPUT CHANNELS
1. Chose under
INPUT MODE
the setting
6CH
.
2. Chose under
OUTPUT MODE
the setting
2
.
Note:
If you do not operate an additional amplifier on the audio output
LINE OUT E/F
, no adjustments on
channel pair E / F
are required.
INTERCONNECTION EXAMPLE
5-channel-mode: 2 x Stereo-System (Front & Rear) + 1 x Subwoofer
Summary of Contents for Thor TRX4004DSP
Page 38: ...38 NOTES...
Page 39: ...39 NOTES...
