Hifonics Brutus BXi6000D, Owner'S Manual

Page: 21 / 28

MODE
BXi 8000D
1x4000 Watts
SLAVE IN/OUT
MASTER SLAVE
LOGO BADGE GND BATT +12V
SPEAKER OUTPUT
+ – + –
POWER INPUT
REM
BLUE
WHITE
LOGO BADGE GND BATT +12V
SPEAKER OUTPUT
+ – + –
POWER INPUT
REM
BLUE
WHITE
MODE
BXi 8000D
1x4000 Watts
SLAVE IN/OUT
MASTER SLAVE
BXi6000D · BXi8000D
21
INTERCONNECTION MASTER
• Connect the RCA lineouts of the headunit with the RCA jacks LINE INPUT of the amplifier with appropriate high-value RCA cables.
If your headunit is equipped with a additional subwoofer lineout (SUB OUT), it is recommended to use this lineout.
• Connect the remote wire (REM) to the remote terminal (REM) of the MASTER amp.
• Connect the bass remote wire only on the REMOTE port of the MASTER amp.
INTERCONNECTION SLAVE
• Connect the RCA jacks SLAVE IN/OUT of the MASTER amp with the RCA jacks SLAVE IN/OUT of the SLAVE amp with appropriate
high-value RCA cables.
• Connect the remote wire (REM) of the remote terminal (REM) of the MASTER amp with the remote terminal (REM) of the SLAVE amp.
Use a cable with a minimum profile section of 0,5 mm
2
INTERCONNECTION SUBWOOFER
• Check page 22.
SETTINGS MASTER
• The MODE must be set to MASTER position.
Check the information for LOW PASS, SUB SONIC, PHASE, LEVEL, SUB BOOST, FREQ RANGE, Q-CONTROL and BASS
REMOTE on page 20.
SETTINGS SLAVE
• The MODE switch must be set to SLAVE position.
In the SLAVE mode all controllers of the SLAVE amp are without function.
Only the already modified audiosignal of the MASTER amp will be amplified.
INTERCONNECTION EXAMPLE Master/Slave Mode
1. Connect Stereo RCA output (L/R
or SUB OUT) of the headunit with the
LINE INPUT CH1/2 of the MASTER amp Connect the bass remote*
controller and the remote terminal
on the amplifier (MASTER)
with the enclosed cable.
Switch setting = MASTER
SLAVE MASTER
Switch setting = SLAVE
Remote wire REM
Remote wire REM
2. Connect Stereo RCA output (SLAVE IN/OUT)
of the MASTER amp with the SLAVE IN/OUT
of the SLAVE amp
1.
2.
* optional