VertX V1000 (CS) Quick Installation Guide
St e p 1
Con n e ct
1 .1
W h a t you n e e d be for e ge t t in g st a r t e d
Prior to starting the installation, please completely read this guide.
CAUTION: The V1000 is sensitive to Electrostatic Discharges (ESD). Observe precautions while
handling the circuit board assembly by using proper grounding straps and handling precautions at all
times.
1 .2
V 1 0 0 0
1. Verify the battery jumper is installed in the ON position (or
OUT position on old covers), P15 connector (V1000).
Out
2. Verify that the V1000 termination jumper is in the
position when there are no panels attached to the port. If
there are downstream interface panels attached then the
termination jumper should be in the
In
position. The V1000
is shipped with jumpers in the
Out
positions.
1 .3
M ou n t in g I n st r u ct ion s
1. The V1000 should always be mounted in a secure area.
2. Mount the V1000 using the four mounting screws
(provided) or other appropriate fasteners. Place the
fasteners in the corner holes of the base.
3. The V1000 can be stacked with or without the cover. Do not remove the plastic base. Make sure you
position the V1000 in such a way as to provide room for wiring, air-flow and cable runs.
1 .4
W ir in g V e r t X
CAUTION: Connectors on the V1000 right and left sides are positioned as mirror images and are not
interchangeable once the installation is complete. Therefore, you cannot simply unplug a connector
from one side and plug it into the corresponding connector on the other side of the board.
1
. Network
Connection:
Connect the V1000 to the network using a standard Cat5 network patch
cable. Connect one end of the Cat5 network patch cable to the
J1
(RJ-45) connector on the V1000
and the other end to the network connection point (network jack, hub, switch, or router) on your site.
October 2006
Page 5 of 20
© 2006 HID Global Corporation. All rights reserved.
