© 2018 HID Global Corporation All rights reserved.
Installation Guide
Page 3 of 26
Web-Based Access Control Solution
ACW2-XN
4
Installation Preparation
System Requirements
•
Compatible browser (See details on page 14)
•
Access to a mains power outlet.
•
Access to an Ethernet Network point or a router/switch that will allow network connectivity.
•
In the absence of any network, HID Access Manager can be set up and administered by
connecting a desktop/laptop PC directly to the Controller Module with an (uncrossed) network
cable.
Suggested Tools
•
Electric drill
•
Drill bits (Masonry / steel – to suite the site wall materials)
•
Screwdriver, small, flat
•
Wire strippers
•
Side cutters
•
Site plan (to lay out door and reader locations)
Additional Hardware
•
Electric strike locks and/or mag locks
•
Power supply with sufficient capacity to power the locks (see calculations on page 19)
•
Push buttons for Request-to-Exit (REX)
•
Door Position Sensor (DPS) switches (if not built into the locks)
•
Mains power cable with a plug on one end
•
Cable for Wiegand Readers, sufficient for the site (measure the site)
•
Cable for Door Position Sensor and Request-to-Exit, sufficient for the site (measure the site)
