5.2.1. Stabiliser system and ground conditions
Always:
• Make sure that the ground can support the load that
the stabiliser leg imposes on the ground.
(*)
• Make sure that the ground is not undermined.
• Use the extra support plates that are large and firm
enough for your loader model.
The maximum permitted ground inclination under
the stabiliser leg plate is 5º.
DANGER
Check that the extra support plates do not bend or sink into the ground.
Do not lower the stabiliser legs on the edge of an embankment, soft ground,
hollows, etc… Lower the stabiliser legs only on to a flat, firm and stable surface.
Loader with tiltable stabiliser legs
1.
If the stabiliser extensions are equipped with a
separate lock (2), release it before the stabiliser
extension can be extended.
2.
Make sure the stabiliser extensions are extended a
little, so the stabiliser leg can be rotated freely of the
vehicle.
3.
Unlock the stabiliser leg lock (1).
4.
To tilt the stabiliser leg use lever or button for stabiliser
leg. Make sure that you have full control of the
movement to avoid risk of crushing.
5.
Lock the stabiliser leg lock (1).
6.
Extend the stabiliser extension until the yellow mark is visible. If the stabiliser extensions are
equipped with a separate lock, lock it with the handle (2).
7.
Operate the stabiliser leg downwards until it is set to the ground.
Starting loader operation
34
HIAB J14S J24S
