HF PackerAmp V4, Construction Manual

Page: 28 / 76

HF PACKER
AMP
V4R6 Page 28
•
Insert in the panel with the two connections away from
the base plate of the case.
•
In the On-Line position, the switch is shorted. That puts
the two terminals of the switch the greatest distance
away from the LED. The depressed switch lever would
be next to the LED.
•
Insert the LED into the hole adjacent to the rocker
switch.
•
Slip four 1/8 inch length of red shrink on the wires
equally spaced. Shrink the tubings.
•
Cut the wires to be equal length for termination into a
four pin Molex connector.
•
Strip 1/8 inch insulation from each wire and crimp
Molex pins on the wires.
•
Insert the wires in the 4 position Molex Housing (last).
Power Pole Physical Installation
•
Locate the bottom notched keeper used to retain the
Power Pole Housing in the panel.
•
Locate the Red and Black Power Pole pieces.

The Power Pole housing can be joined in various ways.
There is one standard that is used on the HF PACKER-AMP.
Looking at the front of the red/black housing, mate the two
pieces side to side with the red on the left and the contacts in
the lower position.
•
The top keeper is in the top mounting hole with the tab
extending into the hole between the red/black housing.
Use a black 4-40 x ¼ inch screw with split washer and
nut.
•
Install the bottom keeper in the bottom mounting hole
with the tab extending up into the hole between the red
and black housing. Use a black 4-40 x ¼ inch screw
with split washer and nut.
•
Secure the screws tight while keeping the keeper
pieces level. When complete, the power pole housing
will be able to move around a bit (float).