Heyner 7971, Manual

Page: 13 / 41

27 28
Thread the diagonal belt through the side belt guide
(E)on bottom of the headrest and tighten it in the di-
rection of the retracting mechanism. Make sure that
the diagonal belt lies firmly against the child‘s body
and is not twisted. All belts must lie tightly against
the child’s body without being twisted. The lap belt
must lie flat over the child’s thigh.
Lock the three-point belt buckle and secure the
lock tongue (V) from the three-point belt of the vehicle into the three-point belt buckle with an
audible << CLICK
IMPORTANT:
The diagonal belt should be centred over the child‘s shoulder,
the lap belt should run as low as possible over the groin.
Make sure that the diagonal strap is straight and not too close to the
child‘s neck. All straps must be tight against the child‘s body and must not
be twisted.
Between the straps and the body of the child may only fit a flat hand.
If necessary, use the vehicle’s belt height adjuster to correspond to your child’s
height. Please check the belt-run at least every six months and adjust the backrest to the new
size of your growing child. Make sure that the lap belt runs through the fixation lugs (C)on both
sides of the booster seat and that the diagonal belt goes only to the side leading to the belt
buckle.
Attention:
Never fasten the lap seatbelt differently, otherwise the child will not be held properly.
4.3. Releasing the ISOFIX
Press the release button and release it from the ve-
hicle‘s anchorage point. With an audible >>click<<<
unlocks the ISOFIX anchorage. You can now remove
the child seat. Push the ISOFIT Adjustment Button
and turn the ISOFIX locking arms back into the seat
shell.
5. Care and cleaning
5.1. Removing the cover
For the later correct installation we recommend to document the removal of the cover with
photos.
You can wash the cover with a mild detergent in the machine (30 ° C). Please note the instruc-
tions on the washing label. Please never use chemicals or bleaching agents.
The plastic parts can be cleaned with lukewarm water and a mild detergent. Do not use sharp
detergents (such as solvents).
5.2 After an accident
After an accident it is required to replace the whole child restraint system or to send it to the
manufacturer for inspection - together with the accident report.
5.3 Product information
If you have any questions, please contact your dealer first.
You should have the following information at hand:
Serial number (see sticker)
Make and model of your car
The child‘s weight, age and height.
Further information and additional car seats for older children can be found at
www.h-germany.de