HEX H103A, User Manual, Page: 18 / 32

Hex Power System H103A
8. Grid(AC) Connection
16
8.2 AC Connection Method
To connect to an inverter, the supplied AC plug connector must be attached to an AC cable.
You can assemble the AC plug connector in the following sequence. There are L, N, Ground
Marks on the AC connector. Connect L to the L-phase, N to N-phase and Ground to the
Ground to the ground wire(Take special care about the L and N connections)
접지
L
N
Cable Condition
Use 4SQ or higher HIV cables.
Procedure
1. Uncover the cable, insert the plug, and fasten
with a screwdriver.
2. Push the connector and plug until it clicks into
place and fasten the screw joint at the bottom.
3. When the assembly of the AC cable and AC plug
cable connector is completed, insert the AC connector
of the inverter until it clicks into place as shown in the
figure
Warning !
The Ground must be connected
to a ground wire.
Ground