Figure 30 Identifying 8/80 SAN Switch nonport side LEDs
6. Power supply #1 status LED
1. Power supply #2 status LED
7. Power supply #1
2. Power supply #2
8. Fan assembly #1 status LED
3. Fan assembly #3
9. Fan assembly #2 status LED
4. Fan assembly #2
10. Fan Assembly #3 status LED
5. Fan assembly #1
Port side LED activity for the 8/80 SAN Switch
describes LEDs and recommended actions.
Table 8 8-Gb SAN Switch port side LED patterns
Recommended action
Status of hardware
LED color
LED name
Verify that the system is powered on
(power supply switches to 1), the
System is off or there is an
internal power supply failure.
No light
Power status
power cables are attached, and your
power source is live. If the system
power LED is not green, the unit may
be faulty. Contact your switch service
provider.
No action required.
System is on and power supplies
are functioning properly.
Steady green
Verify that the system is on and has
completed booting.
System is off or there is no power.
No light
System status
No action required.
System is on and functioning
properly.
Steady green
Verify that the fan FRU and power
supply FRU are seated correctly.
Faulty fan FRU or power supply
FRU, boot failed, or the system is
faulty.
Steady amber (for
more than five
seconds)
Replace the fan FRU or power supply
NOTE:
This LED displays
steady amber during POST. This
is normal and does not indicate a
fault.
FRU, if necessary. If the fan or power
supply FRU is not the problem, do the
following:
1.
Connect a serial cable to the
system.
2.
Reboot the system.
3.
Check the failure message on the
console.
4.
Contact your service provider.
Check the management interface and
the error log for details on the cause
Attention is required. A number of
variables can cause this status,
Flashing amber/green
of the status. Contact your switch
service provider.
including a single power supply
failure, a fan failure, or exceeding
one or more environmental
ranges.
Port side LED activity for the 8/80 SAN Switch
53