8.
If you are installing one of the following devices, install the plenum included in the switch
accessory kit:
•
SAN Switch 2/8V
•
SAN Switch 2/16
•
SAN Switch 2/16V
•
4/8 SAN Switch
•
4/16 SAN Switch
•
4/32B SAN Switch
•
8/8 SAN Switch
•
8/24 SAN Switch
See
for complete installation instructions.
If you are installing a different device, see
Securing the switch to the outer rails (page 37)
to complete the rack mount procedure.
Installing the plenum (if required)
1.
Place the device (with inner rails attached) on a flat surface (see
NOTE:
illustrates how to attach the plenum to the 4/8 or 4/16 SAN
Switch, but this procedure also applies to other switch models that require a plenum.
Figure 21 Attaching the plenum to a 4/8 or 4/16 SAN Switch
3. Two screws that secure the rails to the plenum
1. Plenum (installed)
2. 4/8 or 4/16 SAN Switch
2.
Locate the four 8-32 x .312 Phillips panhead SEMS screws in the accessory kit. These are
the same screws used to attach the inner rails in
of the preceding section.
3.
For each inner rail (left and right), use one screw hole marked
8
and one screw hole marked
16
to attach the plenum.
CAUTION:
Verify that the open end of the plenum faces the rear of the switch. When installed
properly, you should see the plenum's air vent holes on one side, and the front panel of the switch
on the other.
36
Installing and configuring an 8-Gb SAN Switch