Aruba Instant AP | Troubleshooting Guide
10
Run the
show dhcpc-opts
command to view DHCP options received from the DHCP server. If the DHCP
options, option 43 and option 60, are not displayed in the output, configure the options again in the
DHCP server and retry provisioning. Ensure to use the correct syntax when configuring the DHCP options.
The following is the syntax to configure the DHCP options:
DHCP Option
Syntax
Example
Option 060
ArubaInstantAP — for Instant AP
deployments
ArubaInstantAP
Option 043
<Organization name>, <AirWave IP>,
<AirWave Shared key>
Aruba, 192.0.2.20, 12344567
<Organization name>, <AirWave domain
>
Aruba, aruba.support.com
The sample below displays the DHCP options received by the AP, generated by the
show dhcp-opts
command:
[Instant AP]# show dhcpc-opts
------------------DHCP option43 --------------------
Not available
Check if the AP has AirWave IP Configured
APs will not use DHCP options for provisioning if AirWave IP is configured as AirWave configuration takes
precedence over DHCP options.
Run the
show summary
command to view the configuration summary of the AP. In the configuration
summary, check the AirWave server line to determine if the AirWave IP is configured. If AirWave IP is
confiigured, clear all configurations and reboot the AP to provision using the DHCP options.
The sample below displays the summary of AP configuration, generated by the
show summary
command:
[Instant AP]# show summary
Name
:SetMeUp-CF:77:34
System Location
:
Domain
:
VC IP Address
:0.0.0.0
VC IPv6 Address
:::
AP1X
:NONE
VC VLAN
:0
VC Mask
:0.0.0.0
VC Gateway
:0.0.0.0
VC DNS
:0.0.0.0
IP Mode
:v4-only
Cluster-Security DTLS:disable
Content Filtering
:disable
Terminal Access
:enable
Telnet Server
:disable
Activate Disable
:disable
Organization
:
Disable ciphers
:
Airwave Server
:
Airwave Backup Server:
Airwave Prov Backup
:
Number of VC transition
:0