3. Usage of the tool
1) First you have to check the LED indicator is light or not. If the indicator is light on
for more than 5 seconds, it means no power of the battery and should change
the full powered battery to settle on the tool
2) Select the right dies for the Intended application.
Don’t operate the tool with our dies.
Insert the dies into the “C” opened head by pressing retaining clips. Then the
connecting material shall be positioned in the crimping head correctly. In order to
start the crimping procedure.
3) A crimping process is initiated by switching the trigger. It is defined by the closing
motion of the dies. The connection material is positioned in the stationary half of
the crimping dies and the moving part is approaching the compression point.
4) A crimping cycle is terminated when the dies contracted each other and when
the maximum crimping force is reached. After the crimping cycles is completed
the piston retracts automatically. Afterwards a new crimping cycle can be
initiated or the crimping process can be terminated by opening the latch and
remove the connecting material out of the head.
The crimping process can be interrupted at any moment by releasing the trigger.
Do not put your fingers into the head of the tool during operating. Your fingers
could be pinched very severely.
3. Function description
1.
MCU - automatically detect the pressure during operation and
provide security protect, shut off the motor and reset automatically after
operation.
2.
Auto reset - release the pressure automatically, retract the piston to
the starting position when reached the max output.
3.
Manual reset - can retract the position to the starting positioning
in case of an incorrect crimp
4.
The unit is equipped with a double piston pump which is
characterized by a rapid approach of the dies forwards the connector and a
slow crimping motion.
5.
The crimping head can be smoothly turned by 360° around the
longitudinal axis in order to gain better access to tight corners and other
difficult working areas.
6.
One significant sound will be heard and a red display
flashes if any error occurs.
A white LED illuminates the working space after activating the trigger. It
automatically switches off 10 sec. after releasing the trigger.
7.
The whole tool is controlled by one trigger. This results in any easy
handing and a better grip compared to a two button operation.
8.
Li-ion batteries do neither have a memory effect nor self discharge.
Even after long periods of non operation, the tool is always ready to operate.