18
7.2 Hand sets
Start-up
Insert the power plug into the power socket.
A: raise head section
Press the left side of the top key
(A)
to raise the head section
B: lower head section
Press the right side of the top key
(B)
to lower the head section
C: lower foot section
Press the right side of the bottom key
(C)
to lower the foot
section
D: raise foot section
Press the left side of the bottom key
(D)
to raise the foot section
When using the Mosys Standard system, the upper end position is limited via an electrical
limit switch. If the lower foot section or lower foot section key is activated, while the
slatted frame is in zero position, an anti-trap protection function is activated. You will
hear a clicking sound. This clicking sound is normal and is not an indication that the drive
unit is defective.
7.2.2 RF remote control
(see illustration 3/4/5)
Start-up
Remove protective plastic wrap between battery contacts at the back of the hand set.
Insert the power plug into the power socket
The drive goes into the “learn mode” for approximately 30 seconds (green LED on the
controller flashes; see illustration 10 “I”)
During the learning period, press any button on the remote control for approximately
5 seconds
The radio system is ready for operation. The green LED on the controller (see illustration
10 “I”) lights up during the adjustment
NOTE
Put the drive units one after another into operation and not several at the same time.
If the encoding process has not been completed successfully, repeat the start-up after
about 2 minutes.
After a current interruption or power failure there is no need to encode the system once
again as it maintains the previous encoding.
Additional radio control function (see illustration 3):
G: raise head section/foot section
F: lower head section/foot section
CAUTION
Use the RF remote control only when the bed you want to adjust is within eyeshot.
Please note that other equipment that works within a frequency range of 433 MHz
can interfere with each other.
Remote control battery insertion/exchange (see illustration 3/4/5)
1. Remove the battery compartment cover (see illustration 4 “E”) on the back of the
remote control.
2. Insert the batteries into the battery compartment. Ensure that the polarity is correct
when inserting batteries (see image in the battery compartment).
3. Close the battery compartment cover back and press any button on the remote control.
If the batteries are inserted correctly, the control lamp on the controller (see illustration
10 “I”) should light up at each press of a button.
7.2.1 Hand set cable
(see illustration 2)
