14
Operation manual
Hettich Marketing- und Vertriebs GmbH & Co. KG · Gerhard-Lüking-Straße 10 · 32602 Vlotho · T49 5733 798-0 · www.hettich.com
Hettich Marketing- und Vertriebs GmbH & Co. KG · Gerhard-Lüking-Straße 10 · 32602 Vlotho · T49 5733 798-0 · www.hettich.com
To
deactivate
a pedestal stop / shelf stop position, proceed as
follows:
4. Auto Detect Number of Drives
Besides plug detection, the control unit can also automatically
detect the number of lifting columns plugged in. This feature is
always active during first startup of the control unit and after
returning the control unit to factory settings (see section 8).
Lifting columns plugged in after the first startup of the control
unit will not be detected automatically. For changing the estab-
lished configuration the control unit has to be returned to factory
settings.
Possible situations:
• The control unit is being used for the first time.
• The control unit has been returned to factory settings.
5. Changing the height displayed for the lif-
ting column position
This function is used to individually adjust the height shown on
the manual switch display to the actual height of the LegaDrive
Systems lifting column system.
Follow the steps described below to make this adjustment:
Please note that this adjustment does not modify the
actual position of the LegaDrive lifting column system.
This function is only used to change the value shown on
the display. This function is only available for manual
switches with integrated display.
or
1. Move the desk top to any position in
the lower half of the travelling range to
deactivate the pedestal stop or to any
position in the upper half of the travelling
range to deactivate the shelf stop. To do
this, use the
desk position down
or
desk
position up
buttons until the chosen
position is reached.
and
2. Simultaneously press the
desk position
up
and
desk position down
buttons and
keep both buttons pressed for approx.
10 seconds. The control unit clicks
once
when the position has been deactivated
6. Changing desk height unit (cm or inch)
This function lets you change the memory handset display from
centimetre to inch and vice versa. This function does not alter desk
height:
Press the
SAVE key
.
„
S -“
is shown on the display.
Press the
desk top down
button for approx.
5 seconds.
The display indicator starts to flash.
Then use the
desk top down
button or
desk
top up
button to set the height indicator.
Press the
SAVE key
.
The height indicator is now set to the height
position entered.
SAVE
SAVE
Simultaneously press
memory position
button 1
,
memory position 2
and the
desk
top up button.
Keep this button combination pressed for
approx. 3 seconds.
The display shows
S 1
.
Now release the buttons.
Keep pressing the
desk top up
button until
the display shows
S 5.
The display shows
S 5
.
Press the
SAVE button
.
If the display was previously set to cm, it
will now be changed to inch. If the display
was previously set to inch, it will now be
changed to cm.
2
1
2
1
2
1
SAVE
