HESHBON HL-32X, Operation & Maintenance Manual, Page: 25 / 36

22
Operation procedure of manual descent
Remove the cover of the powerpack.
Remove the solenoid valve hexagon
cap (19mm) in the middle of the pump
manifold.
Turn the emergency cock lever (a)
very slowly anti-clockwise. Too much
movement will increase descent speed
too much.
Open the control panel and install a
pressure gauge in the pump manifold
as shown. The pressure adjusting
screw (a) is sealed by the factory.
Remove the seal and adjust the
pressure with a screwdriver. This
should be done while pressing the
ascent button at the same time and
with the lift loaded with the full rated
capacity.
Steps after completing the operation
▶Turn the lever clockwise and lock it
securely when the lift reaches bottom
position.Replace and refit the hexagon
cap. Request after sales service to
check the lift.
Turn the emergency cock lever
very slowly to ensure that descent
speed is slow and safe, especially
if there is a vehicle on the lift.
The pressure is set by the factory.
The lift may be damaged if the
operator increases the pressure.
If the equipment does not lift the
rated capacity,contact your lift
supplier for engineer assistance.
Information for the authorized
service engineer only
HL-32X - 250 Kgf/㎠
Powerpack pressure
2
Proper pressure by model
■ Auxiliary lift platform
extensions
Maintenance
Maintenance